ITEM 93904
HOLOGENVEHICLEWORKLIGHT
Bulb Replacement Procedure:
1. To replace the Halogen Vehicle Worklight Bulb you must first remove
the glass lens in front of it. First remove the worklight from the vehicle,
place it on the ground with a soft cloth or rag under it.
2. The glass Lens is held in by the rubber lip of the light housing. To
remove it peel back the rubber lip of the Worklight then pull out the glass
lens. CAUTION: The glass lens is difficult to remove. If you are not com-
fortable doing this it should be done by a qualified service technician.
3. Once the lens is out remove the H3 bulb and replace it. You will not need
any tools to remove and replace the bulb.The bulb has two wires on it that
are held in by a clip. Pull the bulb straight out to remove it then insert the
new bulb by pressing it into the clip.
4. The final step is to reinsert the glass lens by firmly pressing it back into
the worklight housing.
1. Always wear ANSI approved safety goggles and gloves when working
with tools and equipment. 2. Replace the bulb at your own risk!
3. DO NOT use a screwdriver or any metal object to pry the glass lens out!
Doing so could break, crack or shatter the glass lens.
01/06
SAVE THESE WARNINGS.
Made in India
|