Intrusion Systems | Commercial Wireless ISW‑EN4216R LCD Receiver
Commercial Wireless ISW‑EN4216R LCD
Receiver
Monitors up to 16 transmitters or repeaters
Text display (LCD)
▶
▶
▶
▶
▶
▶
Cost-effective solution for small systems
Flexible alarm and fault output
Wireless registration
Compatible with a variety of transmitters and control
panels
Secure wireless implementation
▶
▶
Exclusive wireless protocol ensures maximum
performance and reliability
Wireless 900 MHz Band
The ISW‑EN4216R LCD Receiver integrates up to sixteen
900 MHz wireless transmitters into any application. The
Commercial Wireless platform uses diversity reception and
advanced signal processing to reduce dead spots in
transmission areas. The liquid crystal display (LCD) allows
the user to view the current status of all transmitters and
view the history of events. Each receiver stores up to 50
events. The receiver provides versatile options for adding
high performance wireless to an installation.
The Commercial Wireless platform sends redundant
information on several multi-frequency channels within the
FCC Part 15 900 MHz band, providing superior range and
reliability. In comparison, systems that use a single
frequency technology can only send information on one
narrow band channel. Any interference within the band can
cause missed signals. With wireless registration, it is easy
to add this technology to any application.
System Overview
Functions
Powered by Inovonics
Flexible Outputs
The Commercial Wireless platform, powered by Inovonics
wireless mesh network technology, ensures superior range,
reliability, and scalability for commercial applications.
Using a wide range of transmitters and repeaters, this
proven technology provides flexibility and performance to
meet the most stringent requirements. This exclusive
protocol is available only on Commercial Wireless products.
Transmitters and repeater faults and alarms map to any of
the receiver models.
Wireless Registration
There is no external programmer required. The transmitter
is enrolled using a wireless programming routine built into
the receiver. Wireless registration reduces installation time.
Secure Wireless Implementation
Jam detection monitors all channels for the presence of
interference for more than 20 sec. A reset terminal is inside
the receiver, allowing the receiver to accept external reset
signals. The receiver includes a case tamper and internal
antennas for added security.
Commercial Wireless ISW‑EN4216R LCD Receiver | 3
Outputs
Rating:
Types:
1 A, 28 VDC, or 0.5 A, 30 VAC (resistive)
Six on‑board Form C relays for con-
•
necting to any control panel or for
stand-alone wireless applications (NO
or NC)
One NO Receiver case tamper contact
•
closure
One NC Receiver jam input indication
•
Reception Characteristics
Frequency Compatibility:
Transmitters:
902 MHz to 928 MHz
Supports up to 16
Trademarks
Trademark names are used throughout this document. In
most cases, these designations are claimed as trademarks
or registered trademarks in one or more countries by their
respective owners. Rather than placing a trademark symbol
in every occurrence of a trademark name, Bosch Security
Systems, Inc. uses the names only in an editorial fashion
and to the benefit of the trademark owner with no intention
of infringing the trademark.
Inovonics is a trademark of Inovonics Wireless Corporation.
Ordering Information
Commercial Wireless ISW‑EN4216R LCD
Receiver
ISW-EN4216R
Monitors up to sixteen wireless transmitters or
repeaters
4 | Commercial Wireless ISW‑EN4216R LCD Receiver
Americas:
Europe, Middle East, Africa:
Bosch Security Systems B.V.
P.O. Box 80002
5600 JB Eindhoven, The Netherlands
Phone: + 31 40 2577 284
Fax: +31 40 2577 330
Asia-Pacific:
Robert Bosch (SEA) Pte Ltd, Security Systems
11 Bishan Street 21
Singapore 573943
Phone: +65 6258 5511
Represented by
Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, New York, 14450, USA
Phone: +1 800 289 0096
Fax: +1 585 223 9180
Fax: +65 6571 2698
© Bosch Security Systems Inc. 2010 | Data subject to change without notice
T6054672523 | Cur: en-US, V4, 2 Jul 2010
|